G686/G687
Global Mixed-mode Technology
Low Voltage Reset IC
Features
General Description
Monitor Supply Voltages of ±2% Reset Thresh-
The G686/G687 microprocessor (µP) supervisory
circuits monitor system voltages in µP and digital
systems. They provide excellent circuit reliability at
low cost by eliminating external components.
old Accuracy
Internal Set Reset Timeout Period 200ms (TYP)
Manual RESET Input (MR )
Low Quiescent Current : 15µA at VCC=3.3V
Available in three RESET Output Options
Since the sense pin is separated from power supply,
it allows the IC to monitor added power supply. Using
the IC with the sense pin separated from power sup-
ply enables output to maintain the state of detection
even when voltage of the monitored power supply
drops to 0V. The VSEN pin is high impedance and
can be used for application of reset threshold pro-
gramming.
Push-Pull RESET Output (G686L)
Push-Pull RESET Output (G686H)
Open-Drain RESET (G687L)
Guaranteed Reset Valid to VCC = 1V
Power-Supply Transient Immunity
SOT-23-5 Package
Moreover, with the built-in reset timeout delay about
800ms, enables the IC remains asserts after the
VSEN has risen above reset threshold or manual
reset is deasserted.
Applications
Computers
Controllers
Intelligent Instruments
Critical µP and µC Power Monitoring
Portable/Battery-Powered Equipment
Telecom/Networking Equipment
The G686/G687 is available in SOT-23-5 packages.
Ordering Information
ORDER
PACKAGE
OUTPUT TYPE
MARKING
TEMP. RANGE
NUMBER
G686LT11U
G686HT11U
G687LT11U
(Green)
SOT-23-5
SOT-23-5
SOT-23-5
Push-Pull Active Low
Push-Pull Active High
Open Drain
68FLx
68FHx
68GLx
-40°C ~ +105°C
-40°C ~ +105°C
-40°C ~ +105°C
Note: T1: SOT-23-5
1: Bonding Code
U: Tape Reel
Pin Configuration
Typical Application Circuit
Detect
Voltage
VCC
G686/G687
*
100kΩ
R1
1
5
4
MR
RESET
(RESET)
VSEN
MR
**
R2
RESET
(RESET)
2
3
GND
VCC
Manual
Reset
GND
VSEN
SOT-23-5
*
The 100kΩ pull up resistor is only for G687L
R1+R2
R2
()is for G686H
**Adjustable reset threshold voltage is Vth = 0.994 ×
ICC may increased at high TA, Therefore, can not connect
Resistors to VCC to prevent Icc abnormal behavior at high TA.
TEL: 886-3-5788833
http://www.gmt.com.tw
Ver: 0.4
Apr 10, 2012
1